Vulcanized rods

To protect the product from damage, we can vulcanize a soft rubber layer onto the rods. This rubber has a hardness of 30-35° shore. Because the rod is vulcanized over the total length, including the flattenings, this offers optimal protection. With these rods, the centre belt is attached with OGP. Because each rod must be vulcanized in a mold not every width is available.


In determining the correct width of the sieve web, it is important that the rods have the correct “stokmaat”. This is the distance between the two outside rivet holes, C.T.C. When ordering loose rods it is important that you mention the stokmaat as well as the distance between the holes in one end.

types of vulcanized rods

Type G10

Fully vulcanized rod.

Type O10

Fully vulcanized rod which can also be used in combination with sprockets

Type C10

Fully vulcanized rod . This rod has a lip along the entire length so products are  optimally protected.

Type W10

Vulcanized rod. By using this rod, sieve webs are almost ‘closed’. The gap between the rods is approximately 4mm and therefore extremely suitable for dewatering of products.